Commercial Fridge Repair & Service

We restore your fridge’s temperature stability fast — minimising downtime, protecting stock value, and keeping service on track. Our licensed commercial fridge technicians diagnose the root cause, fix it right the first time, and verify the cabinet holds setpoint before handover. Prefer prevention? Our tailored commercial fridge service plans cut energy use and reduce breakdowns across Melbourne.

30 Years Of Experience.

24/7 High Priority Breakdown Service

On Site In 2 Hours For Clients

Servicing All Makes And Models

All Work Fully Guaranteed

Need Emergency Service?

Expert Commercial Refrigeration Repair Melbourne, Same Day Service

24/7 Emergency Call-Out Service

Prompt On-Site Response

All Makes and Models

Minimized Business Disruption

Common Fridge Problems We Repair

Won’t hold temperature

If cabinet temps drift or recovery is slow after restock, it’s usually minor gas loss, mis-set/off-cycle defrost, a mis-reading probe, or choked airflow from over-packing. We verify sensors/setpoints, optimise defrost, seal any leaks and restore steady, food-safe cooling.

Excess frost or icing

Ice on the evap or door frame in glass-door/display fridges points to warm-air ingress (tired gaskets/closers) or incorrect defrost termination. We fit the correct seals, check fans/door heaters (where fitted) and set defrost so coils clear without re-icing.

Water leaks and pooling

Water under the fridge or overflowing pans comes from blocked condensate drains, poor tray fall or incomplete defrost. We clear/flush drains, correct tray levels and clean coils so condensate drains properly (no puddles, no smell).

Unusual noise or hot running

Loud fans, vibration or a very hot condenser discharge usually means a dirty condenser, failing fan motor/bearings, high head pressure or poor ventilation (common on underbench units). We clean/comb fins, replace noisy/weak fans, improve clearances and check operating pressures.

Refrigerant (gas) leaks

Localised frosting, low suction or oil staining at joints hints at a leak. We use electronic/UV detection, carry out a permanent repair, evacuate to deep vacuum and recharge to the nameplate spec, then verify performance.

Controller and sensor faults

Probe errors, nuisance alarms or erratic temps come from failed thermistors, loose terminations, worn contactors/caps or a faulty controller. We load-test, re-terminate, replace suspect parts and recalibrate controls.

Door & seal issues

Condensation, warm-air spill or frequent threshold icing is often torn gaskets, dropped hinges, tired closers or a failed door heater (on some glass-door fridges). We install the right-profile seals, re-hang/balance the door, tune the closer and test heaters.

Electrical/mechanical failures

Won’t start, hard-starts then trips, or high running amps point to failed start gear, fan faults, TXV/EEV issues or overheating. We replace the faulty components, verify pressure safeties and confirm stable operation under load.

Not sure what’s going on?

Tell us the symptoms (temps, alarms, noise, icing) and we’ll talk you through stock-protection steps, then dispatch a nearby commercial fridge technician for fast commercial fridge repair Melbourne — 24/7.

Commercial Fridge Repair Process

  • Triage & fast dispatch – Tell us the symptoms and trading constraints. We prioritise stock risk and send a commercial fridge technician 24/7 with a clear ETA.
  • On-site safety & inspection – Electrical checks, door/seal/airflow assessment, and baseline temps recorded to keep staff and product safe.
  • Diagnosis (no guesswork) – We pinpoint the root cause — leaks, airflow issues or control faults — and confirm what’s needed to stabilise cooling quickly.
  • Repair & stabilisation – Faulty parts replaced, leaks sealed, drainage restored and controls recalibrated for a swift return to food-safe temperatures.
  • Verification & handover – Cooling performance is verified before handover. You receive a clear report with findings, parts and key readings.

Preventative Maintenance for Commercial Fridges

A simple 6–12 month service plan can cut energy costs and extend equipment life — backed by Australian Government energy-efficiency advice for commercial refrigeration. Here’s what we include (kept practical and outcomes-focused):

  • Clean & straighten coils – Improve airflow and keep head pressure sensible for lower power use.
  • Check refrigerant charge & sensors – Ensure accurate readings and consistent cooling performance.
  • Test heaters, fans & controllers – Catch early faults that cause icing, warm spots or nuisance alarms.
  • Clear & flush drains – Stop pooling water and odours; keep hygiene standards up.
  • Calibrate controls & probes – Hold food-safe setpoints and reduce temperature swings.
  • Inspect/replace door gaskets & adjust hinges/closers – Reduce cold-air loss and energy waste.
  • Review setpoints, fan cycling & defrost timing – Tune for efficiency and reliability in your conditions.

Want fewer callouts and steadier temperatures? Ask about our tailored commercial fridge maintenance plans for Melbourne venues.

Why Choose Zeal Group for Commercial Fridge Repair?

  • Rapid, reliable response — 24/7 attendance for urgent faults; punctual scheduling for planned works
  • Qualified technicians — specialists in commercial fridge repair who work safely with refrigerants and electrical systems
  • All major brands & configurations — from prep counters and display fridges to high-capacity storage units
  • Clear communication — findings explained in plain English, pricing guidance and approvals before major parts are fitted
  • Performance-first approach — repairs verified with readings, plus a practical plan to reduce repeat issues
Contact Us

Trusted by Melbourne Businesses for Commercial Fridge Repairs

We deliver commercial fridge repair and service Melbourne-wide for hospitality and foodservice (restaurants, cafés, pubs, clubs), retail and supermarkets (bottle shops, convenience, delis), butchers and specialty grocers, healthcare and aged-care (hospitals, labs, facilities), plus food manufacturers and distribution centres. If you need commercial fridge repair Melbourne fast, we’re nearby and available 24/7 to keep your operation running.

Play Icon
CLOSE X
Play Icon
CLOSE X
Play Icon
CLOSE X

Frequently Asked Questions

Do you offer after-hours emergency support?

How fast can you get to our site in Melbourne?

Do you cover my area / near me?

Which brands and models do you service?

What can we do right now to protect stock while waiting?

How often should we schedule maintenance?

What does a typical repair include — and is the work guaranteed?

Are your technicians licensed?

How do you price the work?

Can you work outside trading hours to avoid disruption?